Switching Off And Securing The Vehicle; Adjusting The Fork Height - Jungheinrich ECR 327 Instrucciones De Servicio

2.4

Switching off and securing the vehicle

When the vehicle is left, even for a short time, it must be switched off and secured.
Qw W
Do not park the vehicle on a slope.
– Lower the fork completely.
– On vehicles with a locking tiller (13,
B (this releases the lock).
– Turn the switch latch (1) to position "0" and remove the key.
2.5

Adjusting the fork height

IMPORTANT In the event of wear on the drive
wheel or support rollers, the fork
base height or fork tip height
must
necessary to ensure that the
fork can still be moved easily
into and out of pallets.
The fork base height is adjusted with a
bolt and counter nut located between the
load frame and drive frame (20) on both
sides.
The fork tip height is adjusted with the pull rod adjusting nuts (21).
IMPORTANT These adjustments may only be made by authorized and appropriately
trained employees.
E 14
13
be adjusted. This
1
o
), push the tiller into the upper braking range
is
21
20