Jungheinrich ETR 314 Manual De Instrucciones página 53

Startup
When the EMERGENCY OFF switch and the switch latch (if applicable) are turned
on, the LED (57) lights up red.
The LED (57) turns green after the correct operator code is entered.
If an incorrect code is entered, the LED (57) will flash red for two seconds. You will
then need to re-enter the code.
NOTICE In user mode, the Set key (56) has no function.
Switching off
To turn the vehicle off, press the
o key (61).
NOTICE The vehicle can be programmed to
switch off after a predefined time.
This requires the corresponding
code lock parameter to be set.
1.4.2 Parameters
In programming mode, the code lock
functions can be adjusted.
Parameter groups
The parameter number comprises three digits. The first digit indicates the parameter
group as shown in Table 1. The second and third digits are numbered consecutively
from 00 to 99.
No. Parameter group
0xx Code lock settings
(codes, travel program enables, automatic shutdown, etc.)
E 22
58
59
1
4
7
Set
56
57
60
2 3
5 6
8 9
61
0