Snap-On ATC 970S Manual De Instrucciones página 22

1
22 - EN
2 3
4.1-4
4.1-2
4.1-2a
9
10
4.1-3
Specifi cations
Turntable rotation
- Press pedal (2, Fig.4.1-4); WITH THE RIGHT FOOT;
the wheel-holder fl ange rotates clockwise as follows.
1 st speed:
- About 3/4 of the way down, the turntable rotates at
the minimum speed (approx. 7 rpm).
nd
2 speed:
- All the way down, the turntable rotates at the
maximum speed (approx. 20 rpm).
- If the pedal is raised the turntable rotates anticlockwise
(approx. 7 rpm).
Tool holder arm
To prevent collisions with the wheel or the turntable,
the tool must be placed in the fully
position.
BRING THE TOOL TO THE FULLY RAISED POSITION
TO PREVENT ANY COLLISION WITH THE WHEEL
OR THE TURNTABLE.
- Press the Home key to bring the tool back to rest
position.
W A R N I N G : T H E O P E R AT I O N S C O U L D
B E D A N G E R O U S . F O L L O W T H E S A F E T Y
INSTRUCTIONS INDICATED ON THE APPLIED
PLATES
Figure 4.1.-2
HAND CRUSHING HAZARD
Figure 4.1-2a
HAZARD, MOVING PARTS
3
Bead breaker
To activate the upstroke and downstroke of both
bead breaker arms (Master, Slave) act on the manual
controls (3, 4, Fig.4.1-3):
- Control (3) up; the upper Bead Breaker moves up.
- Control (3) down; the upper Bead Breaker moves
down.
- Control (4) up; the lower Bead Breaker moves up.
- Control (4) down; the lower Bead Breaker moves
down.
4
Note: When released, each control lever returns
to the rest position and the relative
machine movement stops.
Figure 4.1.-2
WARNING: HAND CRUSHING HAZARD
raised and stopped