Testing Procedures; Pneumatic Hose Connection Check; Instructing The Operator - Snap-On ATC 970S Manual De Instrucciones

Installation
iv.

Testing procedures

Motor rotation check
This type of check must be made on machines at the
end of installation only.
• Press the turntable rotation control pedal: the wheel
must start and turn clockwise.
Should it rotate anticlockwise the machine must be
stopped and must not be used until it has been repaired
by an authorized technician.
ANY DAMAGE CAUSED BY NON APPLICATION
OF THE ABOVE INSTRUCTIONS SHALL NOT BE
DEBITED TO THE MANUFACTURER AND SHALL
VOID THE WARRANTY.

Pneumatic hose connection check

When fi rst setting the machine into operation, check
hose connections and fi ttings for leakage.
v.

Instructing the operator

(Following applies only if a unit is installed by a service
Technician)
• Show the operator how to switch the unit on and
off.
54 - EN