Locking The Rim; Use Of The Lifter (If Any) - Snap-On ATC 970S Manual De Instrucciones

70 kg MAX.
26 - EN
5.1-1
ü
5.1-2
Operations
5.1

Locking the rim

5.1.1 Use of the Lifter (if any)

WARNING: IN CASE OF HEAVY WHEELS, USE THE
SUITABLE LIFTER LOCATED ON THE MACHINE
LEFT SIDE
Should the operator need to use it, the machine is
provided with a lifter that brings the wheel or the rim
from the ground to a suitable height to be fi xed on the
machine.
This prevents unnecessary and potentially dangerous
efforts.
Lifter correct use:
Figure 5.1.1
• Roll the wheel or the rim until reaching the lifter
board. It is necessary to place the rim LH drop
centre on the machine outer side.
IMPORTANT!
1 THE RIM DROP CENTRE, WHERE PRESENT, MUST
ALWAYS BE POSITIONED UPWARDS, NEXT TO THE
DEMOUNTING TOOL
(Fig. 5.1-2)
Move up the control pedal of the Lifter (1) by following
the wheel or rim movement with a hand to ensure
stability.
• Once the desired height is reached, release the
pedal.
• Tilt and lay the wheel or the rim on the Wheel
Support Flange.
• Press the Lifter control pedal.
• Release the pedal when the Lifter has reached the
ground.
DO NOT MOUNT AND DEMOUNT THE TYRE WITH
THE LIFTER UP.