P/N: EAL0424G33A
P/N: EAL0413G13A
P/N: 8-23562A
6
- EN
Safety
INSTRUCTION: Safety Label
Meanings
WARNING:MAKE SURE THAT THE SAFETY
SIGNS ARE ALWAYS CLEARLY VISIBILE IN THE
POSITIONS INDICATED BY THE MANUFACTURER
(SEE FIGURE AT THE SIDE).
For any reset, use the Part Number (P/N) listed at
the side.
EAL0413G13A
General Danger.
Take the necessary precautions.
The areas marked with this symbol indicate the presence
•
of a potentional ranger to the operator.
This plate is normally found with a second pictogram,
•
which represents the type of risk in greater detail. The
operator must know the meaning of every pictogram
found on the machine.
When this symbol is found without other plate, it notifi es
•
the operator of a general risk, refer to the User Manual
for the warnings.
Do not operate the machine without knowiong the
•
meaning of the pictogram found in the area concerned.
Do not allow unauthorised people approach the machine.
•
IN ORDER TO USE THE MACHINE THE OPERATOR
MUST KNOW THE MEANING OF ALL THE
PICTOGRAMS FOUND ON THE MACHINE.
8-23562A
Electrical risk. Electric shock hazard.
•
Do not operate equipment with a damaged power cord
or if the equipment has been dropped or damaged, until
it has been examined by a qualifi ed service person.
•
If an extension cord is necessary, a cord with a current
rating equal to or greater than that of the equipment
should be used. Cords rated for less current than the
equipment can overheat.
•
Unplug equipment from electrical power outlet when not
in use. Never use the cord to pull the plug from the outlet.
Grasp plug and pull to disconnect.
•
Do not expose the equipment to rain. Do not use on wet
surfaces.
•
Plug unit into correct power supply socket.
•
Do not remove or bypass grounding wire.
CONTACT WITH HIGH VOLTAGES CAN CAUSE
DEATH OR SERIOUS INJURY.
IMPORTANT!! SAVE THESE
INSTRUCTIONS