Pictographs Used In These Instructions - Lenze TML Instrucciones Para El Servicio

Safety information
Operation
Systems including controllers must be equipped with additional monitoring and protection
devices according to the corresponding standards (e.g. technical equipment, regulations for
prevention of accidents, etc.). You are allowed to adapt the controller to your application as
described in the documentation.
WARNING!
• After the controller has been disconnected from the supply voltage, live components
and power connection must not be touched immediately, since capacitors could be
charged. Please observe the corresponding notes on the controller.
• Do not continuously cycle input power to the controller more than once every three
minutes.
• Please close all protective covers and doors during operation.
1.1

Pictographs used in these instructions

Pictograph Signal word
WARNING!
4
Impending or possible danger
for persons.
Possible damage to equipment
Useful tip: If observed, it will
Note
make using the drive easier
Meaning
Lenze 13466187 EDBTL03 v8 EN, DE, FR, IT, ES
Consequences if ignored
Death or injury.
Damage to drive system or its
surroundings