Changing The Water - Sirona inLab MC XL Manual De Instrucciones

2 Changing the water

inLab water tank
4
2
Changing the water
NOTE: Replace the filter inserts regularly
Replace both filter inserts after every fourth water change.
A
Water tank
A Filter inserts
B Tank cover
When changing the water, proceed as follows:
The unit is switched on.
No milling/scanning process is running.
1. Pull out the water tank at the front of the unit.
2. Open the drain opening.
3. Empty two thirds of the water from the tank.
4. Close the drain opening.
5. Shake the tank vigorously.
6. Open the drain opening.
7. Drain the rest of the milling water.
8. Close the drain opening.
9. Unscrew and remove the tank cover.
CAUTION: Foam not permissible!
If any cleaning agents are used, this will create foam, which is not permitted.
Do not use any cleaning agents.
Sirona Dental Systems GmbH
Supplement to the Operating Instructions
B
A D
C Tank
D Tank drain
D 3439.201.03.01.02 12.2007
C
62 10 350 D 3439