Using The System - TV Ears 2.3 Manual Del Usuario

Installation
Instructions
Step
Charging
3
the Headset
The headset comes pre-charged with enough battery
power for 10 minutes of use. The headset will last up to
1
10 hours on a full charge, depending on volume level.
A fully exhausted battery will take between 8-10 hours
to charge completely. The automatic 1-hour "Quick
Charge" feature will rapidly charge a partially drained
battery sufficiently for typical use, 2-4 hours.
1. Turn the headset volume knob
2. Place the headset in the transmitter - charging
cradle
7
3. Check to see that the charging light
It will glow green if the headset is placed in the front
charging cradle of the transmitter and it will glow
red if placed in the rear - charging cradle of the
transmitter.
GREEN
Front Cradle
TV Ears recommends storing the headset in the
charging cradle of the transmitter when not in use, to
avoid damaging the headset. The headset cannot be
over charged. If returned to the charging cradle of the
transmitter, the headset will always be easy to find and
ready for use.
7
1 to the off position.
facing forward.
6 illuminates.
RED AMBER
Rear Cradle Two Headests
1. Remove the headset from the charging cradle
of the transmitter.
2. The writing on the front of the headset should
face away from your body. The infrared signal is
received on the front of the headset.
3. Using both hands, gently separate the bow arms
and place earpieces into each ear (similar to
placing a stethoscope).
4. The VOLUME control will be located on the
1
RIGHT side. Rotate the dial to turn ON the
headset and set the volume to your comfort level.
5. The TONE control
2 (bass and treble) will be
located on the LEFT side. Rotate the dial to adjust
the tone to your preference.
The TV Ears headset receives an invisible infrared signal
from the transmitter that is connected to the television.
Be certain that the infrared diodes
front of the transmitter are in direct sight with the
front of the headset to receive the signal. The infrared
signal from the transmitter to the headset should be
clear of any obstruction (plants, books, furniture, etc.)
The infrared signal cannot pass through walls or solid
objects. The headset can only pick up the infrared signal
in the same room as the transmitter.

Using the System

Step
Using the
1
Headset
7
located on the
5
8