Mechanical Cooking Programmer; Analog Cooking Programmer - Franke CM 65 M Manual De Instalación Y Servicio

EN

Mechanical cooking programmer

(Fig. 1d)
The end of cooking timer is a practical device that
turns the oven off automatically at a set time in an
interval of 1 to 120 minutes.
9 To use the end of cooking timer, the ringer must
be wound up by turning the knob (B) almost
one full turn clockwise; then, turning back,
set the required time by aligning the number
corresponding to the minutes with the fixed
reference on the front panel.
At the end of the set time, the ringer sounds
„ „
and the oven is automatically switched off.
Note: The oven stays hot
at around the set cooking
temperature for a long time
after it has been switched
off; therefore to avoid
overcooking or burning
the food, it is advisable to
remove it from the oven.
Note: To use the oven in manual mode, i.e. without
using the end of cooking timer, align the knob
pointer with the fixed symbol
When the oven is turned off, the end of cooking
programmer can be used as a normal timer.

Analog cooking programmer

(Fig. 1a)
This clock is already set for manual oven use,
therefore cooking is possible even without
adjusting it.
Right knob
Press the right knob to
X X
select in sequence the
functions to be activated
(timer, end of cooking,
cooking start, time
setting), signalled by the
respective LED blinking.
Press this knob briefly to
X X
check already programmed settings (Query), or
press it for about 2 seconds to cancel settings
(Reset).
B
0
5
20
120
30
100
45
60
80
on the front panel.
B
TIMER STOP
START
– 10 –
Left knob
Turn the left knob to set the hands of the time
X X
clock relevant to the activated function (LED
blinking).
LEDs
9 Blinking: ready for setting or signalling end of
function (together with the ringer).
9 Lit: function running.
Timer
To set the timer, press the knob on the right once
X X
(the corresponding LED begins to blink); then turn
the knob on the left to move the hands in order to
set the timer duration.
Press the right knob again to confirm the setting;
X X
the corresponding LED changes from blinking to
steady.
The hands will then return to their original
„ „
position to indicate the current time: when the
set time is reached, the ringer sounds. This
sound can be stopped by pressing the right
knob.
The timer does not control oven heating.
„ „
End of cooking
To set the end of cooking time, press the right
X X
knob twice (the LED for the
flash); then turn the knob on the left to move the
hands in order to set the end of cooking time.
The LED will blink for the next 10 seconds (for
„ „
possible adjustments), after which the setting
will be acquired and the LED becomes steady.
The same effect is obtained by pressing the
„ „
right knob twice during blinking. At the end of
cooking, oven heating will be deactivated and
the ringer will sound for 1 minute; this sound
can be stopped by pressing the right knob.
Note: At the end of cooking, the oven remains at
a temperature close to the previously set value for
several minutes; it is therefore wise to remove the
food from inside so as to avoid overcooking it.
End of cooking with delayed start
Delayed start of cooking can only be activated
X X
following the end of a cooking process; when set,
pressing the right knob confirms the „stop", and
at the same activates the blinking LED for the
symbol .
Turn the left knob to also set the start of cooking
X X
time (naturally this will be before the end,
therefore the hands can only be moved back).
Confirm by pressing the right knob again.
X X
min
275
60
240
200
100
180
150
symbol begins to