Installing The Led Light Kit; Installing The Glass Shade - Kichler Cameron Manual De Instrucciones

INSTALLING THE LED LIGHT KIT

NOTE: Before continuing installation, confirm that the power is still turned off at the
main circuit breaker or by removing the correct fuse. Turning the power off using a
wall switch is not sufficient to prevent electrical shock.
Step 1. Loosen the two mounting screws on the inside of the light plate then remove
and save the third screw.
Hold the LED light kit close to the light plate and connect the white wires from the
socket plate and the fan by pushing the connectors together. Follow the same
procedure with the black wire connectors. (Fig. 18)
Step 2. Tuck the connections neatly into the light plate. Place the key holes on the
LED light kit over the 2 screws previously loosened from the light plate, turn the
LED light kit until it locks in place at the narrow section of the key holes. Secure by
tightening all three screws. (Fig. 18)

INSTALLING THE GLASS SHADE

Raise the glass shade against the LED light kit and turn clockwise until snug, DO
NOT OVER TIGHTEN. (Fig. 19)
14 | KICHLER.COM
Wire connectors
Light plate
LED Light kit
Fig. 18
LED Light kit
Fig. 19
Screws
Glass
shade