Dismantling/Assembling The Electronics Module - Festo CPX-FVDA-P Serie Descripción Resumida

CPX-FVDA-P...
Note
Because of its size, the DIL switch is a mechanically sensitive component.
S To adjust it, use a suitable small, blunt tool (e. g. watchmaker's screwdriver)
and exercise caution.
1. Turn off the power supplies to the CPX terminal.
2. Remove the assembled connection block (see Fig. 4).
3. Carefully adjust the DIL switch as required using a suitable tool, e.g. a small
watchmaker's screwdriver.
4. Replace the connection block. Observe the correct tightening torques.

Dismantling/assembling the electronics module

Note
Improper handling can cause damage to the electronic modules.
S Never disconnect the electronics module from the interlinking block or press
it into the interlinking block when connected to the power.
To prevent errors during installation, both the interlinking block CPX-M-GE-EV-FVO
and the electronics module CPX-FVDA-P are mechanically coded. The coding
prevents a different module from being plugged into the interlinking block or the
module from being plugged into an incorrect interlinking block.
The plugs connected to the connection block may remain attached whilst dismant-
ling the connection block.
Dismantling the electronics module - see Fig. 4:
1. Turn off the operating and load voltage supplies.
2. Unscrew the screws 9 and carefully lift off the connection block 1.
3. If necessary: Carefully detach the electronics module 2 from the contact rails.
Festo CPX-FVDA-P... 1011NH English
29