Wolf SRT366 Guía De Uso Y Mantenimiento página 8

CA RE R EC O M M EN D ATIONS
Care Recommendations
C L E A NI N G
Stainless steel Use a nonabrasive stainless steel cleaner and apply with a soft lint-free cloth. To bring out the natural luster,
lightly wipe the surface with a water-dampened microfiber cloth followed by a dry polishing chamois. Always
follow the grain of stainless steel.
Burner grates Remove and place on a flat surface near the sink. Clean with hot water and mild detergent or paste of
baking soda and water. Do not immerse in water. Towel dry.
Burner pan Remove surface debris before cleaning to help speed up the cleaning process and decrease the chance of
scratching the surface during cleaning. Using mild abrasive cleaners or spray degreasers, clean and rinse
the surface and dry immediately to avoid streaking. To clean hard water stains, use white vinegar and water.
Rinse and dry immediately.
Surface burners Allow to cool. Use mild detergent or spray degreaser to clean. Rinse with water and towel dry.
Charbroiler Refer to pages 6-7 for care recommendations.
Griddle
French top
Control knobs Using a damp cloth, wipe with a mild detergent or spray degreaser; rinse and dry. Do not place in the
Bezels dishwasher.
|
8 English
TRO U BL E S HO O T ING
Troubleshooting
OP E RATIO N
Rangetop does not operate.
• Verify power is on.
• Verify electrical power to the rangetop and home circuit
breaker is on.
Erratic flame, poor ignition, or no ignition.
• Verify the burner caps are positioned properly.
• Clean the burner and igniter properly.
• If water has spilled over recently, let the area dry
completely. Use a hair dryer, if desired.
• If the burner cap secures to the burner head, verify it is
tightly fastened.
• Push in the knob, then release. Verify the knob springs
back.
Charbroiler clicks continually.
• Verify the knob is set fully at HI.
Griddle indicator light flashes.
• Turn the knob off, then back on. The flame was lost and
the unit entered safety lock-out mode.
S ERV IC E
• Maintain the quality built into your product by contacting
Wolf Factory Certified Service.
• When contacting service, you will need the model and
serial number of your product. Both numbers are listed
on the product rating plate. Refer to page 6 for rating
plate location.
• For warranty purposes, you will also need the date of
installation and name of your authorized Wolf dealer. This
information should be recorded on page 2 of this guide.