Bartscher 70 Serie Instalación Uso Y Mantenimiento página 50

Gas fryer (fig. 15, 16 – pag.6)
To light the burner of the fry top, proceed in the following way:
- turn the knob (1) from the off position
- press down to the bottom;
- push the button of the piezoelectric lighter (2)
- keep the knob pressed down until the thermocouple heats up, keeping the pilot lit; this can be
checked through the slit in the control panel;
- light the main burner, positioning the knob in one of the eight possible positions, choosing the
one most suited to the type of cooking desired, considering that they correspond indicatively to
the temperatures shown below:
Position [N °]
Temperature [°C]
To put out the main burner, it is necessary to turn the knob to the right into the on position
put out also the pilot, turn the knob again into the off position
Gas Fryer with electronic control (fig. 17,18 pag.6)
To light the burners of the gas fryer, proceed in the following way:
- turn the knob (1) from the off position
- press down the button hard;
- push the button of the piezoelectric lighter (2)
- keep the knob pressed down until the thermocouple heats up, keeping the pilot lit; this can be
checked through the hole in the combustion chamber;
- light the main burner to the required setting, by setting the knob to
- regulate the required temperature by using the knob that controls the thermostat (2).
To turn off the main burner, it is necessary to turn the knob to the right into the position
off the pilot, turn the knob again, into the off position
Normal functioning (fig. 19 pag. 7)
When not in operation the instrument shows the temperature revealed by the probe.
To see the set temperature value, press and release the button UP (1), the led at the bottom, to the
right of the display, flashes showing that a setting is being made. Therefore, if a temperature
modification is required, press the buttons UP (1) or DOWN (2) in 4 seconds and regulate as
required.
To change this operation wait 4 seconds without pressing any buttons or press and release the
MELT button (3) or the START/STOP button (5).
ATTENTION! The firm sets the temperature range, and it varies from a minimum level of 0°C to a
maximum of 195°C.
Before activating this function set the working temperature required, using the UP button (1) to
increase the value or the DOWN button (2) to reduce it. Start the heating by pressing the
START/STOP button (5), then the led START/STOP (6) flashes until a temperature close to the set
INSTRUCTIONS FOR USE
into the on position
Q
1 2 3
100 115 130
to the on position
Q
Pag. 49/87
;
to light the pilot burner;
4 5 6
145 160 175
.
Q
;
to light the pilot burner;
.
Q
7
190
, to
, to turn