Bartscher 70 Serie Instalación Uso Y Mantenimiento página 53

ATTENTION! Only use the appliance under surveillance. Never use the fryer when it is
empty. Make sure the burners have been switched off before draining the oil.
Abnormal functioning
If for any reason, the appliance does not start or stops working during use, check that the energy
supply and the control knobs are set correctly; if all is regular, call customer service.
If the anomaly concerns an electronically controlled fryer below is a table indicating the steps to
take.
ALARM SIGNAL
EO flashing and buzzing
E2 flashing and buzzing
EOC flashing and buzzing
PF alternating temperature value
with buzzing
AL1 alternating temperature value
with buzzing
CARE AND MAINTENANCE OF THE APPLIANCE
Cleaning
ATTENTION! Before doing any cleaning, make sure that the appliance is disconnected from
the electric mains and that the gas cutoff valve is closed. During cleaning operations, avoid
using direct or high pressure sprays of water on the appliance. Cleaning must be done when
the appliance is cold.
The parts in steel can be cleaned with warm water and neutral detergent, using a cloth; the detergent
must be suitable for cleaning stainless steel and must not contain abrasive or corrosive substances.
Do not use common steel wool or anything similar which, depositing iron particles, could cause rust
from it. It is also better to avoid using sandpaper or emery paper. Only in the event of encrusted
dirt, pumice stone in powder may be used but an abrasive synthetic sponge or stainless steel wool
would be preferable, to be used in the direction of the grain. After washing, dry with a soft cloth.
If the appliance is out of use for a long time, it is advisable to turn off the gas tap. Then disconnect
the main electricity supply and wipe all stainless steel surfaces with a cloth soaked in vaseline oil in
order to give it a protective film and air the rooms now and again.
Maintenance
ATTENTION! Before doing any kind of maintenance or repairs, make sure that the
appliance is disconnected from the electric mains and that the gas cutoff valve is closed.
The following maintenance operations must be carried out at least once a year by specialized
personnel. It is advisable to have a maintenance contract.
MEANING
Incorrect probe
Probe defect
Temperature above limit
Configuration fault
Circuit fault
Long period power failure
The temperature is too low
Pag. 52/87
ACTION
Call the technician
Try turning off and then on
Call the technician
Call the technician
Press the START/STOP button
Call the technician