Anchor Point Selection; Section 4- Training - Falltech 30 Checkline Temporary HLL Manual De Instrucciones

7441 - 10,000 lb. 1" RB Concrete Anchor
7489 - Vertical Beam Anchor
7535 - Hex-Bar Vertical Beam Anchor
7433 – EcoAnchor, 1 pair (also 7433A and G7433)
778000 – 75' EcoAnchor/Checkline Kit (includes two EcoAnchors and one 75' Checkline HLL)
778100 – 100' EcoAnchor/Checkline Kit (includes two EcoAnchors and one 100' Checkline HLL)
For additional details on anchorage connector compatibility, contact FallTech Technical Support at
800-719-4619 or 323-752-0066.
3.6 – Anchor Point Selection
The Checkline Temporary HLL System is an adaptable anchorage solution, and it may be used to span
a broad area by connecting it to two structural anchor points. Anchor point selection is critical to the safe
operation of this system.
Select your anchor points carefully. In order to ensure a 2 to 1 safety factor, consult the information
below to determine the minimum static strength requirements of your anchor points:
Maximum Horizontal Peak Load:
Minimum Anchor Point Static Strength:
Maximum Horizontal Peak Load:
Minimum Anchor Point Static Strength:
When selecting your anchor points, consult with a competent person or your supervisor. If you have
questions about anchor point selection, be sure to contact FallTech for further guidance.

Section 4- Training

Be sure to utilize this instruction manual in the training of all competent persons and user who will be
responsible for the installation, inspection and operation of this system prior to installation and use. OSHA
requires employers to conduct training of all workers who are exposed to falls under Title 29 of the Code of
Federal Regulations.
For Spans up to 75 feet
1 User
900 lbs. 1,100 lbs.
1,800 lbs. 2,200 lbs.
For Spans greater than 75 feet
1 User
1,300 lbs. 1,550 lbs.
2,600 lbs. 3,100 lbs.
2 Users 3 Users
1,350 lbs.
2,700 lbs.
2 Users 3 Users
1,900 lbs.
3,800 lbs.
4 Users
1,550 lbs.
3,100 lbs.
4 Users
2,200 lbs.
4,400 lbs.