Section 5 - Warnings - Falltech 30 Checkline Temporary HLL Manual De Instrucciones

OSHA describes training in detail in standard number 1926.503 under part 1926, subpart M of 29CFR.
This may easily be viewed and printed by going to
window.
During the course of training, special attention should be paid to the following topics to ensure that
workers are protected from all the ancillary hazards associated with fall arrest:
If you have any questions or concerns about the above topics, please contact a FallTech sales
professional by calling 1-800-719-4619. The FallTech Services Group is available to assist with a wide
variety of issues related to training as well as product and system selection. Please inquire through your
FallTech sales professional.
Be sure to retain documentation of training and to record the use of this system in your fall protection
plan. For details on recommended fall protection plans, consult OSHA 1926 subpart M appendix E, which
is also available at www.osha.gov. Also refer to ANSI Z359.2-2007 (Minimum Requirements for a
Comprehensive Fall Protection Program). Copies of this standard are available for purchase at
www.ansi.org in the "eStandards Store". ANSI standards for fall arrest are also available for purchase at
www.asse.org, and are sometimes priced in bundles with considerable savings over the cost of individual
standards publications.
Section 5 – Warnings
The Checkline Temporary HLL System is part of a comprehensive fall arrest system. In order for this
system to function properly, it must be properly installed and used with system-compatible equipment and
components. Be sure that you have read and understood all of the material in Sections 1 through 3!
You must read and observe all of the warnings below. Failure to do so may cause serious injury or
death.
- Read, understand and adhere to all manufacturer's instructions and warnings prior to the
installation or use of this system.
- Always inspect this system and all other system compatible fall arrest equipment prior to each
use. Any element of the system displaying excessive wear or damage must be immediately
removed from service and replaced.
- This system is rated for one to four users. The maximum weight of any individual user, to
include clothing, tools and equipment, must not exceed 310 lbs.
- Use only system compatible equipment with this system. If you are unsure about the
suitability of your equipment, consult a competent person or contact FallTech before using
this system.
 Clearfall hazards
 Swingfall hazards
 PFAS product selection (Full body harnesses and connecting devices)
 Daily inspections
www.osha.gov and typing "1926.503" into the search