Emission Information - Generac GH-410 Manual Del Propietário

1.4

EMISSION INFORMATION

The Environmental Protection Agency requires that this generator
complies with exhaust emission standards. This generator is certi-
fied to meet the applicable EPA emission levels. Additional infor-
mation regarding the requirements set by the EPA is as follows:
The generator is certified for use as a stationary engine for standby
power generation. Any other use may be a violation of federal
and/or local laws. It is important that to follow the maintenance
specifications in the "Maintenance" section to ensure that the
engine complies with the applicable emission standards for the
duration of the engine's life. This engine is certified to operate on
Liquid Propane fuel and pipeline Natural Gas. The emission control
system on the generator consists of the following:
• Fuel Metering System
• Carburetor/mixer assembly
• Fuel regulator
• Air Induction System
• Intake pipe/manifold
• Air cleaner
• Ignition System
• Spark plug
• Ignition module
Section 1 — General Information
Air-cooled Generators
The Emissions Compliance Period referred to on the Emissions
Compliance Label indicates the number of operating hours for
which the engine has been shown to meet Federal emission
requirements. See the table below to determine the compliance
period for the generator. The displacement of the generator is listed
on the Emissions Compliance Label.
Displacement Category
< 66 cc
 66 cc -
< 225 cc
 225 cc
Compliance Period
A 300 Hours
B 125 Hours
C 50 Hours
A 500 Hours
B 250 Hours
C 125 Hours
A 1000 Hours
B 500 Hours
C 250 Hours
5