Emission Information - Generac 7 kW NG, 8 kW LP, single-cylinder GH-410 Engine Manual Del Propietário

Ocultar thumbs Ver también para 7 kW NG, 8 kW LP, single-cylinder GH-410 Engine:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If during the installation of the home standby system the decision
is made to provide back up power to a bedroom branch circuit,
then the circuit breaker in the transfer switch should be replaced
with an Arc Fault Circuit Interrupter.
It is most important that breakers only be switched like for like.
For instance, if replacing a 15A breaker, it MUST be replaced with
a 15A AFCI breaker. Likewise, a 20A breaker MUST be replaced
with a 20A AFCI.
These AFCI breakers are available at the nearest hardware store.
Item #
Q115AF
Q120AF
1.4

EMISSION INFORMATION

The Environmental Protection Agency requires that this generator
complies with exhaust emission standards. This generator is certi-
fied to meet the applicable EPA emission levels. Additional infor-
mation regarding the requirements set by the EPA is as follows:
The generator is certified for use as a stationary engine for standby
power generation. Any other use may be a violation of federal
and/or local laws. It is important that to follow the maintenance
specifications in the "Maintenance" section to ensure that the
engine complies with the applicable emission standards for the
duration of the engine's life. This engine is certified to operate on
Liquid Propane fuel and pipeline Natural Gas. The emission control
system on the generator consists of the following:
Fuel Metering System
Carburetor/mixer assembly
Fuel regulator
Air Induction System
Intake pipe/manifold
Air cleaner
Ignition System
Spark plug
Ignition module
Description
15A Single Pole AFCI
20A Single Pole AFCI
The Emissions Compliance Period referred to on the Emissions
Compliance Label indicates the number of operating hours for
which the engine has been shown to meet Federal emission
requirements. See the table below to determine the compliance
period for the generator. The displacement of the generator is listed
on the Emissions Compliance Label.
Displacement
Category
< 66 cc
 66 cc -
< 225 cc
 225 cc
General Information
Compliance Period
A
300 Hours
B
125 Hours
C
50 Hours
A
500 Hours
B
250 Hours
C
125 Hours
A
1000 Hours
B
500 Hours
C
250 Hours
5

Publicidad

Tabla de contenido
loading

Tabla de contenido