Complete Installation; Install Duct Covers; Range Hood Use - arietta ATS430SSA Guía De Instrucciones Para Instalación

WARNING: Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire in
terminal box. Failure to do so can result in death or electrical
shock.
7.
Connect green (or bare) ground wire from home power
supply to yellow-green ground wire (F) in terminal box using
UL listed wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10.
Check that all light bulbs are secure in their sockets.
11.
Reconnect power.

Install duct covers

When using both upper and lower vent covers, push lower cover
down onto hood and lift upper cover to ceiling and install with
two mounting screws.
NOTE: For vented installations, the upper vent cover may be
reversed to hide slots.
A
B
A. Upper vent cover
B. Lower vent cover
C. 4.2 x 8 mm screws
Secure the bottom of the duct with 2 - 4.2 x 8 mm screws.
C
D
C
D. Bracket

Complete Installation

1.
For non-vented (recirculating) installations only, install
charcoal filters over metal grease filter. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3.
Check the operation of the range hood blower and light.
See the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.

Range Hood Use

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the kitch-
en. The hood controls are located on the front side of the canopy.
C
D
A
A.Grease filter
B.Grease filter handle
C. Blower and light controls
D. LED lamps
7
B