Electrical Connection; Complete Installation; Description Of The Hood - arietta ASG436SSB Guía De Instrucciones Para Instalación

Electrical Connection

WARNING: Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
• Remove the knockout and the Junction box cover and install
the conduit connector (cULus listed) in junction box.
A
B
C
D
A. White wires
B. Black wires
C. UL listed wire connector
• Run 3 wires; black white and green, according to the National
Electrical Code and local codes and ordinances, in
from service panel to junction box.
WARNING: Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire in
terminal box. Failure to do so can result in death or electrical
shock.
• Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
• Close and secure junction box cover.

Complete Installation

Replace filters.
Check operation of the hood.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house fuse
blown.
• Disconnect power supply. Check that the wiring is correct.
To get the most efficient use from your new range hood, read the
"Maintenance" section.
Keep your Installation Instructions and Use and Care Guide close
to range hood for easy reference.
E
F
D. Green (or bare) and yellow-green ground
wire
E. Home power supply cable
F. UL listed or CSA approved ⁄ " strain relief
1
2
⁄ " conduit
1
2

Description of the Hood

2
3
1. Blower and light controls
2. LED lamps
3. Grease filter handle
4. Grease filter
Control
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after
the cooking is complete to clear all smoke and odors from the
kitchen.
A
A. Lamp Knob
Lamp Performance
1. Turn the knob to position "ON" to turn the lights on.
2. Turn the knob to the "OFF" position to turn the lights off.
Motor Performance
1. Turn the knob to position "1" to turn the hood on.
2. Turn the control to the desired speed.
3. Turn the control to the "HI" position to obtain maximum power
for your hood.
4. Turn the knob to the "OFF" position to turn your hood off.
8
1
4
B
B. Motor Knob