Sime PIROEMME Serie Manual De Instrucciones página 10

contains the fan. For the assembly of
the details proceed as indicated in the
succession of stages below.
4.5. 1 Fan assembly
Take out the fan from the packaging
and proceed as follows:
- Position the gasket and mount the
fan by blocking it with the brass
screws supplied (fig. 12).
- In PIROEMME 6-7, after mounting
the fan unit, install the protective
frame and block it with the four
10
screws supplied (fig. 12).
4.5.2 Bypass device assembly
(fig. 6)
The bypass device is a direct passage
between the wood storage area and
the chimney. It is connected with a
contr ol r od. The
accumulated in the storage area are
thus collected and sent directly to the
chimney.
The bypass device basically allows the
flue gases to be discharged towards
1
the chimney without coming out from
the top door during switch-on and
loading operations.
To mount the bypass device, proceed
as follows:
- Inser t t he block (1) in t he
designated housing by securing it
with the two hex socket screws
supplied.
f lue gases - Mount the lever (2) with the screws
and nuts supplied.
- Insert the control rod (3), block it at
the lever (2) with the locking ring.
We recommend making sure that
the spring and washer have been
2
3
4
Fig. 6