Quick Start Wizard Via The Handheld Programmer - Siemens SINTRANS LR25 Guia De Inicio Rapido

Quick Start Wizard via the handheld programmer

Notes:
• The Quick Start Wizard is a complete package and the settings are inter-related and
changes apply only after you select FINISH in Wizard Complete.
• Each time the Quick Start Wizard is initiated, the start-up settings are factory defaults. The
Wizard will not recall previous user-defined settings
• Default settings in the Quick Start Wizard are indicated with an asterisk (*) unless
explicitly stated.
1. Quick Start
a) Point the programmer at the display [from a maximum distance of 300 mm (1 ft)],
then press RIGHT arrow
b) Press RIGHT arrow
enter the Quick Start Wizard.
c) Press RIGHT arrow
values and move directly to the next item.
d) To change a setting, scroll to the desired item or key in a new value.
e) After modifying a value, press RIGHT arrow
to move to the next item.
f) Quick Start settings take effect only after you select Finish in Wizard Complete.
1.1. Quick Start Wizard
Introduction
Note:
The introduction screen is displayed only on the instrument when using the
handheld programmer. This screen is not part of the Quick Start Wizard when using
AMS Device Manager.
Introduction to Quick Start Wizard showing purpose of wizard: to setup common
applications easily.
Options
Language
Selects the language to be used on the LCD and takes effect immediately.
Options
7ML19985XN82
to activate PROGRAM mode and open menu level 1.
twice to navigate to menu item 1.1 and DOWN arrow
to open Edit mode or DOWN arrow
CANCEL, NEXT
*
ENGLISH
DEUTSCH
FRANÇAIS
ESPAÑOL
简体中文
SITRANS LR250 (FF) – QUICK START MANUAL
to accept default
to accept it and press DOWN arrow
to
Page EN-19