Se Ng Up The Grinder And Inser Ng The Bean Hopper - Mahlkonig E80 SUPREME Instrucciones De Uso

ESPRESSO GRINDER
Please note that the grinder is subject to an extensive func onal
test before delivery and may therefore s ll contain coff ee pow-
der residue.

Se ng up the grinder and inser ng the bean hopper

You will need a fl at-head screwdriver (not supplied) for fi xing the
bean hopper.
1. Place the grinder on a level, stable surface that does not shake or wob-
ble.
2. Make sure that the spout (13) is pushed up as far as possible and is se-
curely locked into the spout locking mechanism (see Fig. D).
3. Make sure that the grinder is switched off (On/Off switch (5) to "0") and
connect the grinder to the power supply by inser ng the power plug into
a properly installed safety socket.
4. Place the collec ng tray (9) into the corresponding recess in the casing
under the spout.
5. Place the bean hopper (1) onto the bean hopper intake (2).
When placing the bean hopper on, make sure that you place the nose
of the bean hopper into the corresponding recess in the bean hopper
intake.
6. Push the bean hopper down into the bean hopper intake and turn the
bean hopper clockwise to fi x it to the grinder.
If the bean hopper cannot be fi xed in place by turning it, it may not be
posi oned correctly. In this case, align the bean hopper correctly (see
step 5) and then try again by pressing it down and turning it (see also the
"Troubleshoo ng" chapter).
The grinder automa cally switches off if the bean hopper is not
a ached.
50