Wire Speed; Arc Length - Sol Welding QUAD Serie Manual De Instrucciones

Instruction Manual
NOTE: the display on the right (85) indicates the new synergic set-
ting according to the largeness selected. (This is so only if the pro-
gramme is set on SYN or PULS).
NOTE: the display on the left (80) indicates the new synergic set-
ting according to the largeness selected.
Adjustment of the

WIRE SPEED

1. Press the know (91)
until the Led (82) turns
on.
2. Regulate the wire speed
using the knob (91).
Adjustment of the
MATERIAL THICKNESS
NOTE: it can be regulated
only if the programme is
set on SYN or PULS.
1. Press the knob (90) until
the Led (87) turns on.
2. Regulate the material
thickness using the knob
(90).
NOTE: if the led "V" (86) is selected,
the display on the right (85) indicates
the new arc voltage.
NOTE: take into account that by
increasing the electronic inductance
the arc becomes narrower and more
pliable. On the contrary, by decrea-
sing the electronic inductance the arc
becomes wider and more "energetic".
QUAD AC/DC SERIES
Adjustment of the

ARC LENGTH

(This allows you to get
either a longer or shorter
arc).
GB
NOTE: it can be regulated
only if the programme is
set on SYN or PULS.
1. Press the knob (90) until
the Led (87) turns on.
2. Regulate the material
thickness using the knob
(90).
Adjustment of the ELEC-
TRONIC INDUCTANCE
(This allows you to get
either a more "energetic"
or "pliable" arc)
1. Press the know (90)
until the Led (88)
turns on.
2. Regulate the electronic
inductance using the knob
(90) (from -9,9 a + 9,9).
3. Return to the regulation
of the current and tension
and carry out the possible
corrections on the welding
parameters.
37 GB