Job Saving - Sol Welding QUAD Serie Manual De Instrucciones

Instruction Manual
13.
JOB SAVINGS
M E M J O B n . 3
i n J O B 1 2 3 4 5 6 7 8 9
E N T E R
E S C
M E M J O B n . 3
i n J O B 1 2 3 4 5 6 7 8 9
E N T E R
E S C
GB
42
1. Once you set the para-
meters press at least for
three seconds the knob
to memorize them.
2. The LCD display (43)
indicates the JOB num-
ber where the new set-
ting could be saved.
3. The highlighted num-
ber on the second line
refers to the suggested
position where to save
the parameters. (As
default it will be shown
the job being used).
4. Select the position
(from 1 to 9) in which to
save the JOB by using
the knob (41).
5. Confirm the saving by
pressing the knob (41).
To exit select the "ESC"
line and press the knob
(41).
M E M J O B n . 3
i n J O B 1 2 3 4 5 6 7 8 9
E N T E R
* *
E S C
M E M J O B n . 3
i n J O B 1 2 3 4 5 6 7 8 9
O V E RW R I T E ?
D E L E T E J O B ?
M E M J O B n . 3
i n J O B 1 2 3 4 5 6 7 8 9
O V E RW R I T E ?
D E L E T E J O B ?
Memorized parameters in the job:
- Current Voltage, wire speed, thickness
- Welding type: Mig o Puls Mig
- Torch Switch cycle
- Arc length
- Double puls and frequency
- Inductance arc value
- Pregas value
- Postgas value
- BBT value
NOTE: when welding with MIG/MAG, Puls MIG, Double Puls MIG,
the JOB savings can be done only if the programme in used is set
on SYN or PULS. (See Chap. 12 to Page 34).
QUAD AC/DC SERIES
6. If the JOB number cho-
sen has already been
used, an asterisk will
appear below it.
7. Pressing the knob (41)
on the OVERWRITE line,
it is still possible to save
the new settings.
8. Select the "DELETE
JOB" line and press the
knob (41) to cancel the
content of the JOB.
- Speed ignition corrector
- Double Puls parameters
(Balance % low and wave form)
- Ignition current
- Up slope time (if used)
- Craterfiller slope time (if used)
- Final current
- Timer (if used)