Taurus V302T Manual De Instrucciones página 24

English
Electric hobs
1. INSTALLATION
Installation Instructions
The appliance must be installed and connected in accordance with current regulations.
After unpacking the appliance, ensure there is no visible damage. If it has been damaged
during transit, DO NOT USE, contact where you buy immediately.
Selection of installation equipment
-Cut out the work surface according to the sizes shown in the drawing.
-For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
-Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant work surface
material to avoid larger deformation caused by the heat radiation from the hotplate. As shown below
(measure by unit: mm):
Under any circumstances, make sure the electric hob is well ventilated and the air inlet and outlet are
not blocked. Ensure the electric hob is in good work state. As shown below:
Note: The safety distance between the hotplate and the cupboard above the hotplate should
be at least 760mm.
Model L W
V302T 288 520
I302T 288 520
V603S 590 520
V604S
I603S 590 520
H D A
52 48 265+5
-0
56 52 265+5
-0
52 48 555+5
-0
56 52 555+5
-0
B X
495+5 50 min.
-0
495+5 50 min.
-0
495+5 50 min.
-0
495+5 50 min.
-0