Taurus V302T Manual De Instrucciones página 39

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
2) Slider Touch control models: V603S, V604S, I603S:
• Touch the timer control button
single digit in timer indicator flashing, then adjust single
digit of minute minder setting by sliding the slider control.
• Press the timer control button again, the number of tens
digit in timer indicator flashing, then adjust tens digit of
minute minder setting by sliding the slider control.
Note: By continuous touch the timer control button, the slider
works at below consequence: "Single Digit-Tens Digit-
Confirm Setting -Single Digit-..."
4. When the timer is set, it will begin to count down
immediately, the display will show the remaining time.
NOTE: The red dot next to power level indicator will
illuminate for those zones be set with timer. You can check
timer setting of different cooking zone which set with timer,
by active this cooking zone.
NOTE: If more than one heating zone has timer setting,
the timer indicator will show the lowest time. The red dot
next to power level indicator will flash.
5. When cooking timer expires, the corresponding
cooking zone will be switch off automatically.
Note: The default setting of minute reminder and timer is 30 minutes.
Note: After adjusting, the setting in timer indicator will flashing for 5 seconds and then stop flashing,
then the setting be confirmed.
Note: The minute reminder and timer can be use at same time, timer indicator shows the lowest time
setting. If the lowest setting is minute reminder, the red dot next to timer indicator will flash. If the
lowest setting is timer setting, the red dot of corresponding cooking zone power level indicator will
flash.
Note: If indicator shows timer setting of cooking zone. To check minute reminder setting, press the
timer control button
Detection of Pan and Small Articles
For induction hob, if display flashes"
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly cantered on the cooking zone.
once, the number of
, the indicator will show minute reminder setting.
"alternately with heat setting.

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

V603sV604sI302tI603s

Tabla de contenido