Taurus V302T Manual De Instrucciones página 34

Always lift pans off the hob – do not slide, or they may scratch the glass.
Notes: You can use any kind of pot or pan for Ceramic Hob.
Suggested Pan dimensions for induction hob
The cooking zones are, up to a limit, automatically adapted to the diameter of the pan. However, the
bottom of this pan is suggested to have a minimum of diameter according to the corresponding
cooking zone. To obtain the best efficiency of your hob, please place the pan in the centre of the
cooking zone.
Base diameter of the pots:
Cooking zone Minimum (mm)
160mm 140
180mm 140
210mm 160
280mm 230
Using your Hob
To start cooking
1. After the hob be connected to electricity and power on.
Press and hold the ON/OFF
a "beep" to turn the hob on. Now the hob enters into Standby mode, all heat setting
indicators and Timer setting indicators shows "-"
2. Place a suitable pan on the cooking zone you wish to use.
• Make sure the bottom of the pan and the surface of the cooking zone are clean
and dry.
3. Set heating level of cooking zone
1) For V302T, V603S, V604S, I302T, I603S, before adjust heating level, need to
touching the heating zone selection control button to select and active the cooking
zone you wish to use.
The heat setting indicator of the selected zone flashing when be active, then you
could adjust its heat level by below:
-Touch control models: V302T, I302T
• Set heat setting by touching the
• If press and hold either of the two buttons, the value will adjust down or up rapidly,
from 0 to 9 in circle.
-Slider Touch control models: V603S, V604S, I603S
• adjust heat setting by sliding the slider control.
Maximum (mm)
160
180
210
280
control button for about 3 seconds till you hear
or button.