Taurus V302T Manual De Instrucciones página 27

2. The electric hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
3. The electric hob shall be installed such that better heat radiation can be ensured to enhance its
reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be heat resistant.
6. A steam cleaner is not to be used.
7. This electric hob can be connected only to a supply with system impedance no more than 0.427
ohm. In case necessary, please consult your supply authority for system impedance information.
Note: For some of the models, there might applied with a power cord with plug. If so, you can
directly plug in socket. Please keep power cord plug out after use, for those model power cord
with plug.
The method of connections shown below.