Stihl FS 94 R Manual De Instrucciones página 10

Ocultar thumbs Ver también para FS 94 R:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
A
Arrows on the deflector (A) (as seen
from the underside) show the correct
direction of rotation of the cutting
attachment. When viewed from above,
however, the cutting attachment rotates
counterclockwise.
Some of the following symbols may be
embossed on the outside of the deflector
in order to indicate the approved
combination of cutting attachment and
deflector.
The deflector may be
used in combination with
mowing heads.
The deflector may be
used in combination with
grass cutting blades.
The deflector may be
used in combination with
brush knives.
The deflector must not be
used in combination with
mowing heads.
8
The deflector must not be
used in combination with
grass cutting blades.
The deflector must not be
used in combination with
brush knives.
The deflector must not be
used in combination with
circular saw blades.
The deflector must not be
used in combination with
brush knives or circular
saw blades.
The deflector must not be
used in combination with
grass cutting blades,
brush knives or circular
saw blades.
Adjust carrying harness and hand grip to
suit your size before starting work. The
machine should be properly balanced as
specified in your instruction manual for
proper control and less fatigue in
operation. To be better prepared in case
of an emergency, practice releasing the
unit from the harness as quickly as
possible.
Starting
WARNING
Start the engine at least 10 feet (3 m)
from the fueling spot, outdoors only.
For specific starting instructions, see the
appropriate section of your manual.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
WARNING
To reduce the risk of injury from blade or
line contact, be absolutely sure that the
cutting attachment is clear of you and all
other obstructions and objects, including
the ground, because when the engine
starts at starting-throttle or with the
choke knob engaged, engine speed will
be fast enough for the clutch to engage
and move the cutting attachment.
Once the engine has started,
immediately blip the throttle trigger or
choke knob, which should release the
starting throttle and allow the engine to
slow down to idle.
With the engine running only at idle,
attach the power tool to the spring hook
of your harness if you are using one (see
appropriate chapter of the instruction
manual regarding "Fitting the Harness".)
WARNING
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
FS 94 R

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Fs 94

Tabla de contenido