Stihl FS 94 R Manual De Instrucciones página 23

3
4
5
1
2
Depending on the cutting attachment, it
may be necessary to use the nut (3),
rider plate (4) and thrust washer (5).
These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Removing the transport lock
Pull the hose (1) off the shaft (2).
N
Machine supplied without mounting
hardware
2
Only mowing heads may be used which
mount directly to the shaft (2).
FS 94 R
Blocking the Shaft
2
7
6
The output shaft (2) must be blocked
with the stop pin (6) or screwdriver (6) to
mount or remove cutting tools. These
parts come standard with the machine or
are available as special accessories.
Insert the stop pin (6) or
N
screwdriver (6) in the hole (7) in the
gearbox as far as stop – and apply
slight pressure.
Rotate shaft, nut or cutting
N
attachment until the stop pin slips
into position and blocks the shaft.
Removing the Mounting Hardware
6
Block the shaft.
N
Use the combination wrench (1) to
N
loosen and remove the nut (2)
clockwise (left-hand thread).
Take the thrust washer (3) off the
N
shaft (4). Do not remove the thrust
plate (5).
Mounting the Cutting Attachment
WARNING
Use a deflector that matches the cutting
attachment – see "Mounting the
Deflector".
English
1
2
3
4
5
21