Push-Pull Calibration; Push-Pull Force; Torch Calibration; Max Inching - Cebora KINGSTAR 400 TS Manual De Instrucciones

7�3�3�2 Push-Pull Calibration
Use encoder I to select Push-Pull Calibration mode.
Insert the welding wire into the Push-Pull torch, ensuring that it emerges from the torch current nozzle. When indicated,
open and close both rollers, i.e. for the main motor and for the Push-Pull motor.
7�3�3�3 Push-Pull Force
7�3�4

Torch Calibration

This activates only when Item No 443 KIT SRS - SPATTER REDUCTION SYSTEM is installed.
7�3�5

Max Inching

88/109
Use knob I to select Push-Pull Force mode.
This is active for both Binzel Push-Pull and Custom Push-Pull.
This function adjusts the drive torque of the Push-Pull motor in order to
ensure the welding wire feed is linear.
Adjust by turning knob I, confirm by pressing.
The adjustment ranges from +99 to -99
Use knob I to select Torch Calibration mode.
Connect the terminal provided in the kit to the part to be welded.
Press the Enable Calibration pushbutton.
Rest the electrode of the MIG torch against the part to be welded and
ensure there is a good contact.
Press the torch pushbutton 2/3 times, checking that the parameters
displayed are almost the same (Test1 and Test2).
Press the SAVE pushbutton to save the parameters.
Exit Torch Calibration mode, keeping the terminal provided with the kit
connected to the part to be welded.
Use knob I to select Max Inching mode.
The purpose is to stop the welding machine if the wire emerges for the
preset maximum length in cm after starting with no passage of current.
Adjustment OFF - 10 cm.
Use knob I to set the desired value. Press to confirm.
3301065/A