Cooling Unit; Welding Mask; Push-Pull Torch; Push-Pull Torch Custom - Cebora KINGSTAR 400 TS Manual De Instrucciones

7�3�1

Cooling unit

The cooling unit to be used with the KINGSTAR power source is Item No 1683 - GRV12.
On power source Item No 372.XX it is optional, but standard on power source Item No 374.XX.
The status bar DN always shows the cooling unit icon
OFF, ON, AUTO.
7�3�2

Welding mask

T-LINK system that resets reaction time of the filter mounted on the welder's mask wirelessly, ensuring maximum eye
protection and reduced eye fatigue. For details, refer to the user manual for Item No 434.
If the mask is recognised, the icon appears in section DN of the display
As soon as welding current starts to flow through the workpiece, the mask is automatically darkened. To check the
function, press the "DARK" key on the display and ensure the mask glass goes dark.
7�3�3

Push-Pull Torch

Activates only when Item No 447 KIT DRIVER PUSH-PULL is installed.
7�3�3�1 Push-Pull Torch Custom
3301065/A
and unit status is shown in the upper part of the icon:
Encoder I is used to select/activate the operating mode:
OFF Cooling unit disabled.
ON Cooling unit always on.
AUTO Cooling unit operates in synchrony with the welding process
Select ON and press PAIR
Use encoder I to select Push-Pull Torch mode.
Two types of torch can be called up:
Binzel torch: connect a Binzel torch with 42 VDC motor to the
wire feeder, the machine is ready to weld. Both wire feed motors,
the main and the Push-Pull motor, are already synchronised.
Custom torch: if a general Push-Pull torch with 42 VDC motor is
connected to the wire feeder, the main motor must be synchronised
with the Push-Pull motor
Use encoder I to select custom Push-Pull mode.
Activate torch calibration mode using this selection; "Push-Pull
Calibration"
.
87/109