Disassembly And Reassembly Of The "Sensor" Plate; Pyrolytic Self-Cleaning - De Dietrich DOP8360W Guía De Utilización

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

4
CARE
DISASSEMBLY AND REASSEMBLY
OF THE "SENSOR" PLATE (FIG. D)
You can dismantle the "SENSOR" plate
indicating the presence of a humidity
sensor linked to the CHEF mode as it
is not essential for operation. Use the
plastic wedge supplied to dismantle the
door glass.
Disassembly :
Slide the plastic wedge between the
"SENSOR" plate and the top of the oven
and make a downward movement to
unclip it.
Reassembly :
Grasp the "SENSOR" plate and
firmly insert the notches
corresponding slots upwards.

PYROLYTIC SELF-CLEANING

This oven is equipped with a pyrolytic
self-cleaning function:
Pyrolysis is a cycle during which the
oven cavity is heated to a very high
temperature in order to eliminate soiling
from splattering and spills.
Before starting pyrolysis cleaning,
remove any large overspills, if any.
Remove the excess grease on the door
using a damp sponge.
As a safety measure, cleaning only
occurs after the door locks automatically;
it is impossible to unlock the door.
Remove the accessories and
supports from the oven before
beginning pyrolysis cleaning.
PERFORM A SELF-CLEANING
CYCLE
Proposed cycles:
This specific function uses the heat
built up during a previous cooking cycle
to quickly and automatically clean the
inside of the oven: it cleans a mildly
dirty oven interior in less than an hour.
The electronic oven temperature
monitor determines whether the
residual heat remaining in the oven
interior is sufficient to provide a good
cleaning result. If this is not the case,
a 90-minute ECO pyrolysis cycle will
automatically begin.
into the
A
for more in-depth cleaning of the inside
of the oven.
IMMEDIATE CLEANING (fig. E)
The programmer must only display the
time. It should not be flashing.
Turn the function selector to one of the
self-cleaning functions.
The pyrolysis cycle begins. The time
starts to count down as soon as it is
set (press the knob).
During pyrolysis, the symbol
displayed in the programmer to indicate
that the door is locked.
At the end of the pyrolysis cycle, 0:00
flashes.
ashes. The oven is clean again and
ready for further cooking operations.
19
PyroExpress in 59 minutes.
Pyrolysis 2h00
When the oven is cool, use a
damp cloth to remove the white
is

Publicidad

Tabla de contenido
loading

Tabla de contenido