Festo SFC−LAC IO Serie Manual De Instrucciones página 15

1 User
Intended use
Motor controller SFC−LAC is the positioning and position
controller for the HME linear module.
The master controller (PLC/IPC) is connected via the con
troller interface:
Type SFC−LAC−...−IO: digital inputs/outputs
Type SFC−LAC−...−PB: PROFIBUS−DP
Type SFC−LAC−...−CO: CANopen
Type SFC−LAC−...−DN: DeviceNet
Commissioning and parameterisation use:
the FCT software package and the SFC−LAC plug−in via
the RS232 interface or
for type SFC−LAC−...−H2 optionally with the control
panel (display and four operating buttons).
Note
This brief overview is part of the P.BP−SFC−LAC operator
package. It is for initial information only and does not
replace the complete documentation, which is con
tained as a PDF file on the CD ROM supplied.
S You must unconditionally observe the information
and the safety instructions in the complete manual of
the motor controller.
S Please consult your local Festo Service or write to the
following e−mail address if you have any technical
problems: service_international@festo.com
Festo P.BE−K−SFC−LAC 0707a English
instructionsEnglish
15