Blackmagic Design Cintel Manual De Instalación Y Funcionamiento página 73

The primaries bars make color adjustments easier when using a mouse.
For more accurate control of each color using a mouse, you can change the color wheels to
'primaries bars' which let you adjust each color and luminance channel for the lift, gamma and
gain controls separately. Simply select 'primaries bars' from the dropdown menu near the top
right of the color wheels.
Adjusting the 'lift':
‚
dial underneath the first color wheel. Slide it back and forth and watch how it affects
your image. You'll see the brightness of the dark regions of your picture increase
and decrease.
Set it to where you want the dark areas to look their best. If you decrease the lift too
much, you'll lose details in the blacks and you can use the parade scope to help avoid
this. The optimal position for blacks on the waveform is just above the bottom line of
the parade scope.
Adjusting the 'gain':
‚
the highlights which are the brightest areas of your clip. The highlights are shown on
the top section of the waveform on the parade scope. For a brightly lit shot, these are
best positioned just below the top line of the waveform scope. If the highlights rise
above the top line of the waveform scope, they will clip and you will lose details in the
brightest regions of your image.
Adjusting the 'gamma':
‚
it back and forth. As you increase the gamma you'll see the brightness of the image
increase. Notice the middle section of the waveform will also move as you adjust the
gamma. This represents the mid tones of your clip. The optimal position for mid tones
generally falls between 50 to 70% on the waveform scope. However, this can be
subjective based on the look you are creating and the lighting conditions in the clip.
You can also use the curves palette to make primary color corrections. Simply click to create
control points on the diagonal line inside the curve graph, and drag them up or down to adjust
the master RGB contrast at different areas of image tonality. The optimum points to adjust are
the bottom third, mid, and top third of the curve line.
There are many more ways of doing primary color correction in DaVinci Resolve.
With your clip selected on the color timeline, click on the 'lift'
Click on the 'gain' dial and slide it back and forth. This adjusts
Click on the 'gamma' dial underneath the color wheel and slide
Working with Clips in DaVinci Resolve 73