Festo 404-1 System Instrucciones De Utilizacion página 37

The Joining station combines the handling functions "inspection" and "joining".
The inspection function assigns certain properties to differently oriented workpieces by acquiring data
(actual values) and comparing them with predefined values (setpoints).
Depending on the properties determined, either a joining process is started or the workpiece is passed
through at the deflector. The workpieces have to be transported individually so that they do not get mixed
up and the joining process is not impaired.
Distance sensor output signals
The distance sensor supplies both an analog and a binary output signal. The binary
switching output can be adapted to the measurement requirement via a simple teach-
in process.
Thanks to the bus node expansions, the Pick&Place module can be used with various bus protocols
depending on the controller.
The station has been expanded for the MPS System 404-1 Industry 4.0 to include the RFID module.
For additional information, please see the following document:
Joining station, document no. 8065303
You can find this document on the internet at the following address:
www.ip.festo-didactic.com
© Festo Didactic 8150266
404-1 System, Distributing Pro-Joining-Measuring Pro-Sorting Inline – Operating instructions
37