Zemper PZD-250 Manual Del Usuario página 41

8- If a luminaire is recognized but it is not included in the plans, and theoretically it has not been installed,
proceed as follows:
Switch-on this luminaire in order to find it (see "Selective switching-on luminaire").

Once located switch it off (see "Selective switching-off luminaires").

If the luminaire is installed in the place of another luminaire would be installed (following plans) change

the number of the luminaire in order to give it the one that corresponds (see "Change of the luminaire
already installed").
If in the place where the luminaire is installed no one figures in the plan, add it on the plan and give it a

free number of the zone of it is installed. Number the luminaire with the assigned number.
9- Once the points 7 and 8 are done and corrected proceed to a new recognition of the luminaires installed (see
"Recognition of the luminaires with PZD-250 programmer").
10- Consult the recognized luminaires and check that all the luminaires installed appear and that the numbers
recognized correspond to those indicated on the plan.
11- If a luminaire does not appear, check individually its number. For this disconnect it from the rest of the
luminaires, connect it to the programmer and proceed to recognise it (see "Recognition of the luminaires with
PZD-250 programmer"). Its number will surely be duplicated. Number again the luminaire with its correct
number.
12- Repeat this process (from 1 To 11) as you are installing the luminaires, zone by zone, floor by floor or section
by section, so that you can clear the possible problems that can appear in the installation.
41