Density Determination - Uline OHAUS RANGER 7000 Manual Del Usuario

NOTE: The I/O's will only work when the I/O option
board have been installed. The I/O option
board provides two isolated inputs and four
dry-contact normally open relay outputs which
can be used for simple process weighing.
Press the button to enter the Main Menu.
With the button corresponding to the
down the list and highlight Application Mode. Enter this
submenu by pressing the button corresponding to the
icon. (See Figure 61)
Figure 61
In the Application Mode menu enter the Dynamic
submenu. (See Figure 62)
Figure 62
The Dynamic submenu is now displayed. Select the list
item and press the button corresponding to the
icon to change the setting as desired. (See Figure 63)
Figure 63
PAGE 21 OF 105
OPERATION CONTINUED
The scale can be used to determine an object's density.
Two types of density determination can be made:
1.
2. Solids less dense than water
icon, go
Press the
upper left portion of the home screen. Before making
density measurements, establish the Application Settings.
1.
2. Check the object weight in air. When prompted
3. Check the object weight again in liquid. When
THE DENSITY HOME SCREEN
Application Setup
The Application can be customized for various user
preferences. Press the button corresponding to the
Figure 64
The Configuration Menu is now displayed. (See Figure 65)
Figure 65

DENSITY DETERMINATION

Solids more dense than water
button until Density is displayed in the
Press the button corresponding to the
press the button corresponding to the
prompted press the button corresponding to the
icon. The density of the object will be displayed.
icon to enter Configuration. (See Figure 64)
icon to start.
icon.
Main Display Line
Reference Fields
Functions
0721 IH-7991