Warranty - Brill 41 E Manual De Instrucciones

Always use the equipment solely
for the purpose described in the
operating instructions.
GB
Only work in daylight or with
adequate artificial lighting.
Ensure that you are standing safely
and on firm ground, even on a
slope. Work across the slope, never
up and down. Do not work on
excessively steep slopes. Be careful
if you change direction on a slope,
turn the machine round or draw it
towards you. Be careful if you are
going backwards, risk of stumbling!
Only push the equipment at
walking pace.
Turn the motor off if the equip-
ment has to be tilted when trans-
porting it over surfaces other than
grass and if you are transporting
the equipment backwards and
forwards to the work area. Never
use the machine with damaged
protective devices or without pro-
tective devices.
When starting or operating the
starter switch take care as stipulat-
ed by the manufacturer's instruc-
tions. Ensure that your feet are far
enough away from the cutting tool.
When starting or switching on the
motor, the machine should not be

Warranty

The manufacturer warrants its
products for exclusively non-com-
mercial use for a period of
24 months from the date of origi-
nal purchase. This warranty does
not affect statutory warranty claims.
The warranty covers all substantial
faults of the product, which are
caused by defects in material and
workmanship. If a product exhibits
such a defect we will, at our
option, repair or replace it without
cost for parts and labour provided
the following requirements are ful-
filled:
The product must have been
.
sold to the customer in a legally
correct way.
22
tilted unless the machine has to be
raised during the process. In this
case only tilt it as far as absolutely
necessary and only raise the side
away from you.
Do not start the motor when you
are standing in front of the dis-
charge duct.
Keep your fingers and feet away
from the cutting tool!
Never lift or carry a machine with
the motor running.
Each time you have to work on the
machine or leave it or top it up,
always switch off the motor.
If you strike an obstacle when
working, please disable the
machine. Unplug from the mains.
Remove the obstacle, check the
equipment for any damage and
have it repaired if necessary.
If the equipment begins to vibrate
strongly, unplug from the mains
and ascertain the cause.
Taking
A
a Break
Never leave the equipment unat-
tended. If you stop work, unplug
the equipment from the mains and
store the equipment in a safe place.
The original receipt with the
.
customer's address, date of pur-
chase, model and product desig-
nation is presented as proof of
purchase. The product must have
been purchased within the EC.
The product was handled proper-
.
ly and according to the recom-
mendations in the operating
instructions. It is essential that the
product has been maintained
and cleaned according to the
information in the operating
instructions. No attempt to disas-
semble or repair the product has
been made by either the buyer
or an unauthorised third party.
It must be ensured that only origi-
.
nal replacement parts and origi-
nal accessories approved by the
If you stop work to go to a differ-
ent work area, it is essential to turn
the equipment off and unplug from
the mains.
Beware of Environmental
A
Influences
Never use the equipment in the
rain or in damp, wet conditions.
Never work immediately adjacent
to a swimming pool or garden
pond with electrical equipment.
Comply with local quiet periods in
your community!
Electrical
A
safety
Check the power cable regularly
for damage and signs of wear.
Only use permitted extension
cables.
Unplug the mains plug immediately
if the mains cable / extension cable
is damaged or severed.
manufacturer are used. There
may be an increased risk of con-
sequential damage and accidents
if non-original parts or non-
original accessories are used.
This warranty does not cover
consequential damages.
The product must be either taken
.
directly or sent with postage paid
to an authorised service centre.
The original receipt must be sent
with the product.
The warranty does not cover
.
damage from misuse, abuse, use
of unsuitable, non-original or
unauthorised interchangeable
parts, replacement parts or
accessories, as well as improper
maintenance and cleaning.