Initial Setup - Integra Codman CereLink Manual Del Usuario

EN - ENGLISH

INITIAL SETUP

Unpack the ICP Monitor
1
WARNING: Use only Codman approved accessories with the ICP Monitor (see the Recommended Accessories and Reordering
Information section).
Remove the contents from the shipping box and verify the following items are included:
• CereLink ICP Monitor (REF 82-6820)
• Power Cord with Region-Specific Adapter Plug (REF 82-6822)
• Rechargeable Lithium Ion Battery already installed (REF 82-6824)
• Extension Cable (REF 82-6845)
• User Manual
After unpacking the contents, inspect the items for any signs of damage. If any damages are discovered, notify the carrier and
the supplier. Retain all shipping contents and boxes for examination.
Prepare the Power Cord Adapter Plug
2
Remove the Power Cord from the package and attach the region-specific adapter plug to the Power Adapter.
Plug the ICP Monitor into AC Power
3
Connect the Power Adapter to the ICP Monitor by inserting the connector end into the Power Input (see Figure 2). Insert the
plug end of the Power Cord into a wall outlet and ensure the Power Indicator light is green. Use the Power Cable retention
mechanism (see Figure 3) to prevent the Power Cord from detaching from the ICP Monitor.
Charge the Battery to Full Capacity
4
Keep the ICP Monitor plugged in for at least 5 hours to charge the battery to full capacity.
Turn on the ICP Monitor
5
Press the Power Button on the front of the ICP Monitor for at least 1 second (see Figure 1). The Power Button will illuminate
to indicate that the device is on. After approximately 20 seconds, while performing internal self-checks, the ICP Monitor will
display the "Codman CereLink" logo. Confirm that the battery is fully charged.
Specify the Language
6
From the Home Screen, select Settings (see Figure 9), then select Set Language (see Figure 10). Choose the desired language.
Set the Time and Date
7
From the Home Screen, select Settings (see Figure 9), then select Set Time/Date (see Figure 10). Adjust the time and date as
needed.
Set the Alarm Volume and Screen Brightness
8
From the Home Screen, select Volume/Brightness (see Figure 9), then adjust desired alarm volume and desired screen display
brightness.
Turn off the ICP Monitor
9
Press the Power Button on the front of the ICP Monitor for at least 3 seconds (see Figure 1). The ICP Monitor will display the
"Codman CereLink" logo to indicate that the shutdown process has started.
16