Scan Mode - Leica RANGEMASTER 2800.COM Manual De Instrucciones

SCAN MODE

6 1
The Leica Rangemaster can also be used for
continuous measurements (scan mode):
Press and hold the main button 2 at the second press.
After around 2.5 seconds, the device switches to scan
mode and then carries out continuous measurements.
Scan mode is indicated by a change in the display.
Around every 0.5 seconds, a new measured value is
shown.
6 3
7 2
Scan mode is particularly useful for measuring the
distance to small, moving targets.
Notes
• In scan mode, the
ABC ABC
p. 45) appears only after the last measurement.
• Power consumption is much higher in scan mode
than for single measurements.
compensation value (see
EN
45