Setting The Ballistic Curve - Leica RANGEMASTER 2800.COM Manual De Instrucciones

Setting the ballistic curve

Start with step 1 if you have not previously opened the
menu control, or with step 3 if you have just set the
unit of measure and is still flashing in the display.
bAll
1. Press and hold the secondary button
• appears.
EU.US
2. Press the secondary button
• is displayed.
bt
3. Press the secondary button briefly (<2 s) 1 time.
• The display switches to the ballistic curves
bALL.
Press the main button 2.
4.
• The display switches to
5. Select a ballistic curve by pressing the main
button repeatedly.
– to or to US12, or
EU1 EU12 US1
– if you wish to use a curve previously
CuSt
stored by the app
– Select if you don't want to display an
OFF
impact setting shown on the distance display
(AbC, see p. 53 ff).
– under bt, menu item
data from a relevantly equipped Nielsen-Keller-
mann device (Kestrel Elite models) via
Bluetooth or
®
1
(≥ 3 s).
1
briefly (≥3 s).
or
EU1 US1
if you wish to transfer
LAt
6. Save your setting by briefly pressing the
secondary button.
• The saved setting is initially lit continuously for
4 s as confirmation, then the display changes
first to the zeroing distance setting (SId) and
then disappears.
Once a ballistic curve is set, the device will display the
range value for 2 s and then the calculated correction
value for 6 s after each distance measurement.
EN
49