Steam Cleaning With The Addition Of Cleaning Agent - Dirt Devil AQUA Clean M318 Manual De Instrucciones

5 Steam cleaning
18
2
5.4 Steam cleaning with
the addition of
cleaning agent
19
MAX
1
48
8. To steam-clean, move the appliance back and forth
slowly.
NOTE:
If the steam ready indicator goes out, you can continue
1
working. Only if the steam produced is no longer suffi-
cient, should you release the steam button (Fig. 18/1)
and wait until the steam ready indicator (Fig. 18/2) lights
up again. Then, as required, you can wet the micro-fibre
cleaning cloth again by depressing the steam button
whilst you want to emit steam.
WARNING:
Danger of falling! Always be especially careful when
cleaning smooth floors as well as steps and stairs! Only
work with moderate amounts of steam when cleaning
smooth floors, otherwise a moisture film will be left on the
floor. Using less steam also ensures quicker drying and
reduces the risk of slipping.
ATTENTION:
Do not leave the appliance standing still when in opera-
tion. Keep it moving continuously. Otherwise there will be
increased danger of damaging the surface to be cleaned.
9. Pull out the plug just before finishing the cleaning pro-
cess and use up the remaining steam reserves.
1. Turn the cleaning agent regulator (Fig. 19/1) in the MAX
direction according to how much cleaning agent you
want to add.
2. Proceed as described in
ing without the addition of cleaning agent".
NOTE:
Cleaning agent will be added to the jet of steam until the
cleaning agent tank is empty or you turn the regulator
back to the OFF position.
3. Cover each stretch of floor several times (at least 3) so
OFF
that a closed film of cleaning agent is produced.
Chapter 5.3, "Steam clean-