Verification Points And Care; Verification Points When Receiving; Precautions In The Installation Inspection - WEG ABWC Serie Instrucciones De Instalación, Operación Y Mantenimiento

Tabla de contenido

www.weg.net

6.3 VERIFICATION POINTS AND CARE

Please read the following checkpoints and cautions carefully as they provide critical content that must be confirmed

before unpacking, inspecting, installing, etc.

1. A visual inspection - internal and external - should be performed immediately upon receiving the ABW Compact

before removing it from the truck. If any damage or fault is evident, a complaint against the carrier should be

immediately submitted to the nearest WEG sales office.

2. Unpack carefully to prevent the product from falling of the pallets and means of transportation.

3. After unpacking, install the products at the final installation location as soon as possible. If you cannot install

the products immediately, it is advisable not to remove the packaging. Keep the products in a sheltered place

at approximately 15 °C with less than 50% humidity. Standard packaging for domestic transportation is not

suitable for outdoor storage. If you cannot observe the above conditions, it is necessary to inspect the degree

of damage before installing the products. Improper preservation may affect product quality and create an

additional accident hazard.

1. First confirm that all power sources are completely de-energized.

2. Disconnect all electrical switches that may operate during the inspection.

3. Disconnect all plugs connected to the operating part of the product (shunt opening release, protection relay, etc.).

4. For the withdrawable type, remove the product from the truck until the guide reaches the TEST position. (Basic

inspection is available in the TEST position.)

5. In case of detailed inspection, remove the circuit breaker from the truck safely and place it on the leveled base.

6. Inspect the product.

26 | ABWC Compact Air Circuit Breaker

Tabla de Contenido

Tabla de contenido