Withdrawable Type; Installing The Withdrawable Type; Precautions And Installation Of The Isolation Barrier; Precautions - WEG ABWC Serie Instrucciones De Instalación, Operación Y Mantenimiento

www.weg.net

8.2 WITHDRAWABLE TYPE

8.2.1 Installing the withdrawable type

Install the withdrawable type according to the instructions provided below.
1. Firmly install the truck at the bottom with M8 screws (4ea).
2. Pull the extension rails of the truck forward.
3. Remove the MI protective cap from the mechanical interlock on the right side of the main body.
4. Place the circuit breaker on the rail as shown in the image using the lifting device.
5. Make sure the circuit breaker fits well on the truck.
6. Slowly push the circuit breaker by moving the rail handle.

8.3 PRECAUTIONS AND INSTALLATION OF THE ISOLATION BARRIER

8.3.1 Precautions

1. Do not lay the circuit breaker on its side.
2. Install the circuit breaker on a flat surface. (Level difference up to 2mm).
3. Do not install the circuit breaker in the same direction as the rail when using a profile.
4. Install the circuit breaker at right angles to the rail direction to decentralize the circuit breaker weight.
30 | ABWC Compact Air Circuit Breaker
Figure 8.3:
Figure 8.4: