Troubleshooting - Stryker VISION ELECT HDTV 240-030-960 Guia Del Usuario

Troubleshooting

Before returning your LCD monitor for service, consult the
troubleshooting list below:
Problem
No Picture
Abnormal
Picture
EN-16
Current Status
LED ON
LED OFF
LED Blinking
Oversized,
undersized display,
missing display, or
center shift
Remedy
Using the OSD, adjust the brightness and contrast
to maximum, or reset them to their default
settings.
Check the power switch at the front and back of
the monitor.
Check if the AC power cord is properly connected
to the AC adapter.
Check if the video signal cable is properly
connected at the back of the monitor.
Check if power of the video signal source system
is ON.
Using the Screen Menu, adjust the PHASE,
FREQUENCY, HORIZONTAL, and VERTICAL
settings with non-standard video signal timing.
Wait a few seconds after initial sync of video
signals, or power cycle the monitor.