Installation & Use - arjo Enterprise ENT-ACC32 Instrucciones De Uso

This accessory is intended for use in applying traction to a patient's head, arms and
upper body. It is compatible with Arjo Enterprise® (5000, 5000X, 8000, 8000X,
9000, 9000X), Citadel and Citadel Plus.
Refer to the bed instructions for use to check compatibility before
using this accessory
Traction must only be applied under the guidance of a clinically
qualified person
If a serious incident occurs in relation to this medical device, affecting
the user, or the patient then the user or patient should report the
serious incident to the medical device manufacturer or the distributor.
In the European Union, the user should also report the serious
incident to the Competent Authority in the member state where they
are located.
Installation & use
Remove the head end panel from the bed.
Install the traction assembly (1) on the outside of the backrest frame (2) with the
pole angled up and away from the bed as shown. Position the clamp plate (3) on the
inside of the backrest frame and secure it to the traction assembly with the four
socket head screws (4).
WARNING
2
1
1
3
4