Installation And Use - arjo Enterprise ENT-ACC10 Instrucciones De Uso

Installation and Use

Lower the bed to minimum height and apply the brakes. Use the ACP to disable the tilt
and leg section controls (refer to the bed user manual). Remove the foot end panel.
To install screw clamps or pulley clamps: fully undo the screw and open the clamp.
Position the clamp around the frame. Close the clamp (1), rotate the knob (2) to lock the
clamp together and tighten the screw (3).
Fit the uprights (4) into the accessory sockets (5) at the foot end of the bed.
Attach a double screw clamp (6) to each upright, at the same height above the mattress
platform. Fit the crossbar (7) into these clamps and secure them.
Attach the straight bar (8) using the integral clamp (Note: the straight bar can be fixed in
any suitable position on either upright or the crossbar, according to the type of traction
required. The illustration shows one typical position).
Fit the protective foam balls (9) over the ends of the uprights.
Fit the pulleys (10) to any horizontal part of the frame and attach traction equipment as
required.
2
3
1
3